Close out NCS Expert, disconnect cable, turn off key and start car. Go back through steps #1 and #2 to verify that $522 now appears in the VO.ġ0. Execute Job again, get Job Ended message again.ĩ. Verify that $522 now appears in the list.Ĩ. F2 to enter FA, plug in $522 and click ADD. reading vehicle data in NCS Expert from ALSZ module.Ģ. I don't have PA Soft - if I have to break down and get it I can.ġ. MAN file, and that hasn't helped.Īm I doing something wrong with the coding itself, or is the car reading VO from a third place I'm not writing to that's over-writing the changes I'm making when I start the car? I really don't want to put in a bunch of aftermarket wires to fool the car - any ideas? I've gone into my WORK folder and deleted the. But if I close NCS Expert, turn the car off and turn it back on, I get the same errors/flashing and when I check the VO, $522 isn't there. I'm trying to code the VO to $522 to stop flickering and the bulb out error, but I'm doing something wrong.Īnd coding $522 into both modules that start with 'A.' I'm getting successful coding messages, and when I go back in to check (while in the same session), I see $522 in the FA. I've finally found a set of AL bi-xenons for my 2004 Touring, and got them installed last night. Hi, fanatics - long time lurker, first time poster.
